2600AS-901-01 Rev. B / September 2008 Return to Section Topics 19-141
Series 2600A System SourceMeter® Instruments Reference Manual Section 19: Remote Commands
smuX.trigger.arm.set
X = SMU channel (a or b)
Function Sets the arm event detector to the detected state.
TSP-Link
accessibility
This function can be accessed from a remote TSP-Link node.
Usage smuX.trigger.arm.set()
Remarks • The SMU will automatically clear all the event detectors when the smuX.trigger.initiate
function is executed. This function should be called after the sweep is initiated.
Also see smuX.trigger.initiate
smuX.trigger.arm.stimulus
X = SMU channel (a or b)
Attribute Selects which event will cause the arm event detector to enter the detected state.
Default 0
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage eventid = smuX.trigger.arm.stimulus
smuX.trigger.arm.stimulus = eventid
eventid Event that triggers the arm detector.
Remarks • Set this attribute to zero to bypass waiting for an event.
• Set this attribute to the event ID of any trigger event generator to wait for that event.
smuX.trigger.ARMED_EVENT_ID
X = SMU channel (a or b)
Attribute The armed event number.
TSP-Link
accessibility
This attribute can be accessed from a remote TSP-Link node.
Usage event_id = smuX.trigger.ARMED_EVENT_ID
event_id Armed event number.
Remarks • Set the stimulus of any trigger event detector to the value of this constant to have it respond to
armed events from this SMU.
To Next Page
Loading...
