Keithley 6430

4-2 Ohms Measurements
Ohms configuration menu
Press CONFIG then Ω to access the ohms configuration menu. Use the Rules to navigate
menus in Section 1 to select the various items in the menu tree, which is shown in Figure 4-1.
Menu items include:
• SOURCE — Select AUTO or MANUAL source mode.
• GUARD — Choose OHMS or CABLE guard.
• SRC RDBK — Enable or disable source readback mode.
• OFFSET COMPENSATION — Enable or disable offset-compensated ohms.
The following paragraphs discuss each of these aspects in detail.
CONFIG
Ω
SOURCE
MANUALAUTO
GUARD
CABLEOHMS
OFFSET
COMPENSATION
DISABLEENABLE
SRC
RDBK
DISABLEENABLE
Fi
gure
4
-
1
Ohms configuration
menu tree