11
Limit Testing
• Types of Limits — Discusses the three types of limits: compliance, coarse limits, and
fine limits. Also summarizes the two operating modes; grading and sorting.
• Operation Overview — Covers binning control and pass/fail conditions.
• Binning Systems — Details the handler interface, as well as single-element and
multiple-element binning.
• Digital Output Clear Pattern — Details the digital output bit pattern that occurs after
a binning operation.
• Configuring and Performing Limit Tests — Describes how to configure the
SourceMeter for limit testing and summarizes a typical test procedure.
• Remote Limit Testing — Summarizes limit commands and provides a basic
programming example.
To Next Page
Loading...
