Keithley 6430

1-26 Getting Started
Configuration menus
There are a number of configuration menus that can be accessed by pressing the CONFIG
key followed by the appropriate function or mode key. For example, you can configure the volt-
age source by pressing CONFIG then SOURCE V. Configuration menus, which are summa-
rized in Table 1-5 through Table 1-10, are available for the following operating modes:
• Measure functions (Ω, FCTN): Table 1-5.
• SOURCE V, SOURCE I, and RANGE: Table 1-6.
• REL, FILTER, and LIMIT: Table 1-7.
• TRIG: Table 1-8.
• SWEEP, DIGITS, SPEED, and STORE: Table 1-9.
• ON/OFF OUTPUT and Display (EDIT or TOGGLE): Table 1-10.
These various configuration menus are covered in detail in the pertinent sections of this
manual.