Keithley 6430 User Manual

17-20 SCPI Command Reference
Table 17-10
TRIGger command summary
Command Description
Default
parameter
SCPI
:INITiate[:IMMediate]
:ABORt
:ARM
[:SEQuence[1]]
[:LAYer[1]]
:COUNt <n>
:COUNt?
:SOURce <name>
:SOURce?
:TIMer <n>
:TIMer?
[:TCONfigure]
:DIRection <name>
:DIRection?
[:ASYNchronous]
:ILINe <n>
:ILINe?
:OLINe <n>
:OLINe?
:OUTPut <name>
:OUTPut?
:TRIGger
:CLEar
[:SEQuence[1]]
:COUNt <n>
:COUNt?
:DELay <n>
:DELay?
:SOURce <name>
:SOURce?
Initiate source-measure cycle(s).
Reset trigger system. Goes to idle state.
Path to program Arm Layer:
Specify arm count (1 to 2500 or INFinite).
Query arm count (INFinite = +9.9e37).
Specify control source (IMMediate, TIMer,
MANual, BUS, TLINk, NSTest, PSTest, BSTest).
Query control source.
Set timer interval in seconds (0.001 to 99999.99).
Query timer interval.
Enable (SOURce) or disable (ACCeptor)
bypass.
Query state of bypass.
Configure output triggers:
Select input trigger line (1, 2, 3, or 4).
Query input trigger line.
Select output trigger line (1, 2, 3, or 4).
Query output trigger line.
Output TENTer, TEXit, or NONE.
Query arm output trigger status.
Path to program Trigger Layer:
Clear any pending input triggers immediately.
Specify trigger count (1 to 2500).
Query trigger count.
Specify trigger delay: 0 to 999.9999 (sec).
Query source delay.
Specify control source (IMMediate or TLINk).
Query control source.
1
IMMediate
0.1
ACCeptor
1
2
NONE
1
0
IMMediate
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓

Keithley 6430 Specifications

General

Brand	Keithley
Model	6430
Category	Measuring Instruments
Language	English