Keithley 6430 User Manual

SCPI Command Reference 17-21
Command Description
Default
parameter
SCPI
:TRIGger
[:SEQuence[1]]
[:TCONfigure]
:DIRection <name>
:DIRection
[:ASYNchronous]
:ILINe <n>
:ILINe?
:INPut <event list>
:INPut?
:OLINe <n>
:OLINe?
:OUTPut <event list>
:OUTPut?
Enable (SOURce) or disable (ACCeptor) bypass.
Query state of bypass.
Configure output triggers:
Select input trigger line (1, 2, 3, or 4).
Query input trigger line.
Enable input event detectors (SOURce, DELay,
SENSe, or NONE).
Query enabled input event detectors.
Select output trigger line (1, 2, 3, or 4).
Query output trigger line.
Output trigger after SOURce, DELay, SENSe or
not (NONE) at all.
Query when output trigger is going to occur.
1
NONE
2
NONE
✓
✓
✓
✓
Table 17-10 (cont.)
TRIGger command summary

Keithley 6430 Specifications

General

Type	Sub-Femtoamp Remote SourceMeter
Compliance Voltage	200 V
Maximum Output Voltage	200 V
Maximum Output Current	100 mA
Compliance Limit	Programmable
Interface	GPIB, RS-232
Input Impedance	>10^14 Ω