Keithley 6430

SENSe1 subsystem ................................................................. 17-54
Select measurement functions ......................................... 17-54
Select measurement range ............................................... 17-57
Select auto range ............................................................. 17-58
Set compliance limit ........................................................ 17-59
Set measurement speed ................................................... 17-60
Configure and control filters ............................................ 17-60
SOURce subsystem ................................................................ 17-64
SOURce[1] ...................................................................... 17-64
Control source output-off ................................................ 17-64
Select function mode ....................................................... 17-65
Select sourcing mode ...................................................... 17-65
Select range ..................................................................... 17-66
Set amplitude for fixed source ......................................... 17-67
Set voltage limit ............................................................... 17-69
Set delay .......................................................................... 17-70
Configure voltage and current sweeps ............................. 17-71
Configure list ................................................................... 17-76
Configure memory sweep ................................................ 17-77
Set scaling factor ............................................................. 17-79
Sweep and list program examples ................................... 17-80
Soak time ......................................................................... 17-82
SOURce2 ......................................................................... 17-82
Setting digital output ....................................................... 17-82
Clearing digital output ..................................................... 17-84
STATus subsystem .................................................................. 17-86
Read event registers ......................................................... 17-86
Program event enable registers ........................................ 17-86
Read condition registers .................................................. 17-87
Select default conditions ................................................. 17-87
Error queue ...................................................................... 17-87
:SYSTem subsystem ............................................................... 17-89
Default conditions ........................................................... 17-89
Select guard mode ........................................................... 17-90
Initialize memory ............................................................ 17-90
Control beeper ................................................................. 17-91
Control auto zero ............................................................. 17-92
Control NPLC caching .................................................... 17-92
Select power line frequency setting ................................. 17-93
Error queue ...................................................................... 17-94
Simulate key presses ....................................................... 17-95
Read version of SCPI standard ........................................ 17-96
RS-232 interface .............................................................. 17-97