SCPI Command Reference 17-63
:ADVanced:NTOLerance <NRf>
[:SENSe[1]]:AVERage:ADVanced:NTOLerance <NRf> Set moving filter noise filter
Parameters <NRf> = 0 to 105 Specify filter noise filter in %
Query :NTOLerance? Query filter noise filter value
Description When the advanced filter is enabled, using the next command, a noise win-
dow is used with the moving filter. This command is used to specify the
noise window. If readings are within the noise window, the moving filter
operates normally. If, however, a reading falls outside the window, the
buffer is flushed of old readings and filled with the new reading.
:ADVanced[:STATe] <b>
[:SENSe[1]]:AVERage:ADVanced[:STATe] <b> Enable/disable advanced filter
Parameters <b> = 0 or OFF Disable advanced filter
1 or ON Enable advanced filter
Query [:STATe]? Query state of advanced filter
Description This command is used to enable or disable the advanced filter. When
enabled, the noise window is used with the moving filter. When disabled,
the noise window is not used.
To Next Page
Loading...
