Keysight E4981A - Setting the Trigger Mode; Perform Successive Measurements Automatically; Specifying Measurement Timing

116 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Executing Measurement
Starting (Triggering) Measurement
6-
Setting the trigger mode
Step 1. Press [Meas Setup].
Step 2. Use the cursor keys to select the TRIG field.
Step 3. Select the desired trigger mode by pressing the appropriate softkey
Perform successive measurements automatically
Select the internal trigger mode according to the procedure in “Setting the
trigger mode” on page 116. In this mode, measurements are automatically
repeated, triggered by the internal trigger signal.
Specifying measurement timing
Generating a trigger manually
Step 1. Select the manual trigger mode according to the procedure in “Setting the
trigger mode” on page 116.
Step 2. Press the [Display Format] key.
Step 3. Press the [Trigger] key to make a single measurement.
Softkey Function
INT Puts the instrument into internal trigger (INT) mode.
MAN Puts the instrument into manual trigger (MAN) mode.
EXT Puts the instrument into external trigger (EXT) mode.
BUS Puts the instrument into bus trigger (GPIB/USB/LAN) mode.