Keysight E4981A - Saving;Recalling Instrument Configuration States

78 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (Save/Recall Function)
4-
USB memory notes
Attention should be given to the following points when using a USB memory
device with the E4981A
• Use a USB memory whose interface is USB 1.1.
• Use a USB memory that is USB mass storage class compliant and
formatted with FAT16 or FAT32.
• Use the USB memory solely for the E4981A. Otherwise, other data
previously saved in the USB memory could be erased.
• If you cannot save into or recall from the USB memory, use another USB
memory device.
• Keysight Technologies shall not be responsible for nor assume any liability
for data loss in your USB memory device after using it with the E4981A.
Saving/Recalling instrument configuration states
Overview of instrument configurations
Pressing the [Save/Recall] opens the CATALOG page. You can save/recall
instrument configuration states in either of two ways:
• Save into the internal memory
•Save into USB memory
You can save up to 10 registers into the internal memory and into a single USB
memory device. Also, register numbers have extensions as shown in Table 4-9:
In this page, you can configure each of the following controls with the cursor
placed in the corresponding field (denoted in parentheses).
• Medium mode (MEDIA field)
• Register number (No. field)
Table 4-9 Extensions for register numbers
Classification
Register number
(No. field)
Extension
Internal memory
0 Recalled when the [Recall A] key is pressed.
1 Recalled when the [Recall B] key is pressed.
2 through 8 -
9 Auto recall
USB memory 10 through 19 -