Keysight E4981A - C.initial Settings; Initial Settings, Settings that Can be Saved;Recalled, Settings that Can be Backed up

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
User Manual
C Initial Settings
This appendix provides initial settings, settings that can be saved/recalled, and
settings that can be backed up.
Initial Settings, Settings That Can Be Saved/recalled, Settings That Can
Be Backed Up
The columns of Table C-1 show the following items.
• Initial settings (factory settings)
• Settings reset from the front panel or the GPIB by the :SYStem:PRESet
command
• Settings reset from the GPIB by the *RST command
• Settings that can be saved/recalled
Table C-1 uses the following symbols.
^: Settings that can be saved/recalled
×: Settings that cannot be saved/recalled
• Settings that can be backed up
Table C-1 uses the following symbols.
^: Settings that can be backed up in the Flash memory
×: Settings that cannot be backed up
The symbol “]” in Table C-1 indicates that the value is the same as that
indicated to the left.