Keysight E4981A - Saving Measurement Results into USB Memory

86 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting up Measurement Conditions and Display
Saving/Recalling Instrument Setup State (Save/Recall Function)
4-
Saving measurement results into USB memory
You can save measurement results obtained by the E4981A into USB memory
as .CSV files. You can later load your saved files into an application program
running on a PC.
Before saving measurement results into USB memory, you need to complete
some tasks preparatory to initiating measurement so that the data buffer
memory contains the necessary data. For more information, see “To save
measurement results into USB memory:” on page 88.
Measurement result format
Measurement results are output in the format shown in Table 4-10.
The Data A and Data B fields of a measurement result file differ depending on
whether the “effective digits” setting is on or off (controlled by the
:FORMat:ASCii:LONG command).
Data A
Outputs the measurement data for the primary parameter.
The Data A field uses the following two different fixed-length ASCII formats:
Data buffer 3 is used to perform save data operation through front panel
and web server. Also, it is not possible to load data through web server.
You cannot load measurement results from USB memory into the E4981A.
Table 4-10 Measurement result format
Measurement
Screen
Comparator Result Format
one point OFF <Data A>,<Data B>,<Status>
one point ON <Data A>,<Data B>,<Status>,<BIN No.>
When the “effective digits”
setting is off:
(:FORMat:ASCii:LONG OFF)
SN.NNNNNESNN
(S:+/-, N:0 to 5, E: exponent character)
When the “effective digits”
setting is on:
(:FORMat:ASCii:LONG ON)
SN.NNNNNNNNNESNN
(S:+/-, N:0 to 9, E: exponent character)