166 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Using Scanner Interface
Control/Check the Scanner Interface for Maintenance
9-
• :TEST:SCANner:TRIGger? gets the Scanner Trigger signal status as
HIGH/LOW.
Ending Scanner interface test
When the Scanner interface test is finished, close the E4981A Scanner
interface test mode by setting :TEST:SCANner:MODE command value to OFF
so that scanner interface pin signal is generated according to the actual
measurement result.
For more information about Scanner Test commands, refer to the Keysight
E4981A Programming Manual.
To Next Page
Loading...
