Keysight E4981A - Ending Handler Interface Test

152 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Using Handler Interface
Control/Check the Handler Interface for Maintenance
8-
• :TEST:HANDler:STATus:RDYTrig sets the Handler Ready for Trigger signal to
HIGH/LOW.
• :TEST:HANDler:TRIGger? gets the Handler Trigger signal status as
HIGH/LOW.
Ending Handler interface test
When the Handler interface test is finished, close the E4981A Handler
interface test mode by setting :TEST:HANDler:MODE command value to OFF
so that handler interface pin signal is generated according to the actual
measurement result.
For more information about Handler Test commands, refer to the Keysight
E4981A Programming Manual.