62 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Setting up Measurement Conditions and Display
Setting Up Display
4-
Setting Up Display
Turning ON/OFF display
You can turn ON/OFF the display with the [Display Format] key.
If you turn OFF the display, DISPLAY NORMAL is always displayed in the
display area for the above items, and you cannot read the measurement result.
However, the measurement time is shortened because no additional time is
required for updating the display.
Setup procedure
Step 1. Press [Display Format].
Step 2. Press the DISPLAY BLANK softkey.
Step 3. If you turn OFF the display, DISPLAY NORMAL is always displayed in the
display area. To return to normal display press the DISPLAY NORMAL softkey.
Using fixed point display for measurement result
The following two display modes can be used to display the measurement
result of the measurement parameter.
Description
Floating point display
(default setup)
The value displayed at each digit is not fixed and changes
depending on the measured value.
Fixed point display The value displayed at each digit is fixed to the value defined by
the user.
The fixed point display is always used to display the deviation percentage
(refer to “Displaying measurement result in deviation from reference value
(deviation measurement mode)” on page 63) as well as to display D and Q.
To Next Page
Loading...
