Keysight E5071C ENA - Page 291

Keysight E5071C ENA Network Analyzers 291
Post-Repair Procedures
Post-Repair Procedures
Imix Perform the following
required adjustments
- Source Output Power
- Receiver Port
Characteristics
- Receiver Absolute Gain
Perform “To Execute the diagnostics
Test” on page 80
Perform the following performance test.
- Frequency Accuracy Test
- RF Output Level Accuracy and Flatness
Test
- RF Output Level Linearity Test
- Trace Noise Test
- Crosstalk Test
- System Dynamic Range Test
- Noise Floor Test
- Dynamic Accuracy test
- Uncorrected System Performance Test
Table 7-3 Post-Repair Procedures for Digital Assemblies
Replaced
Assembly or
Part
Required Adjustments
Correction Constants
(CC)
Verification
CPU Mother
board
Assembly
(A01)
Perform “To configure
the CPU Mother Board
Assembly and BIOS”
on page 115.
Inspect the Booting Process
PCA Front
Key (A52)
No adjustment needed Perform “To Execute the diagnostics
Test” on page 80
Perform “To Check the Front Panel”
on page 96
Handler I/O
Board (A23)
No adjustment needed Perform “To Execute the diagnostics
Test” on page 80
GPIB Board No adjustment needed Perform “To Check the GPIB” on
page 99
Table 7-2 Post-Repair Procedures for Analog Assemblies for Over 8.5 GHz
Options
Replaced
Assembly or
Part
Required Adjustments
Correction Constants
(CC)
Verification