Keysight E5071C ENA - Page 292

292 Keysight E5071C ENA Network Analyzers
Post-Repair Procedures
Post-Repair Procedures
7-
USB
Interface
Card
No adjustment needed Perform “To Check the USB Interface
Card” on page 99
PCA Digital
Board (A53)
No adjustment needed Inspect the Booting Process
Perform “To Execute the diagnostics
Test” on page 80
Perform “To Check the Video Output”
on page 99
Removable
Hard Disk
Drive
Calibration of the Touch
Screen.
Inspect the Booting Process
Power
Supply
Assembly
No adjustment needed Inspect the Booting Process
LCD TPANEL
Assembly
Calibration of the Touch
Screen
Inspect the Booting Process
Perform “To Execute the diagnostics
Test” on page 80
Perform “To Check the LCD” on
page 97
Table 7-3 Post-Repair Procedures for Digital Assemblies
Replaced
Assembly or
Part
Required Adjustments
Correction Constants
(CC)
Verification