Keysight MP4300 Series - Page 22

IEEE-488 Common Commands
*CLS Clear status command.
*ESE<value> Event status enable command and query.
*ESR? Event status event query.
*IDN? Identification Query.
*OPC Sets the OPC (operation complete) bit in the standard event register.
*OPC? Returns a 1 to the output buffer when all pending operations complete.
*OPT? Returns a string identifying any installed options.
*RCL<value> Recalls a saved instrument state.
*RDT? Returns a description of all installed output modules.
*RST Resets the instrument to pre-defined values that are either typical or safe.
*SAV<value> Saves the instrument state to one of ten non-volatile memory locations.
*SRE <value> Service request enable command and query.
*STB? Status byte query.
*TRG Trigger command.
*TST? Self-test query.
*WAI Pauses additional command processing until all pending operations are complete.
LXI
:IDENtify
[:STATe] 0|OFF|1|ON Turns the front panel LXI identify indicator on or off.
:MDNS
[:STATe] 0|OFF|1|ON Sets the MDNS state
MEASure
[:SCALar]
:CURRent
[:DC]? (@<chanlist>) Takes a measurement; returns the averaged current.
:VOLTage
[:DC]? (@<chanlist>) Takes a measurement; returns the averaged voltage.
1 Quick Reference
22 Keysight MP4300 Series Operating and Service Guide