Keysight MSOX3054T - 10 Labels

161
Keysight InfiniiVision 3000T X-Series Oscilloscopes
User's Guide
10 Labels
To turn the label display on or off / 161
To assign a predefined label to a channel / 162
To define a new label / 163
To load a list of labels from a text file you create / 164
To reset the label library to the factory default / 165
To add an annotation / 166
You can define labels and assign them to each analog input channel, or you can
turn labels off to increase the waveform display area. Labels can also be applied to
digital channels on MSO models.
To turn the label display on or off
1 Press [Display] > Label.
2 Press the Display Labels softkey to turn the label display on.
This turns on labels for the displayed waveforms. Labels are displayed at the
left edge of the displayed traces.
The figure below shows an example of displayed labels.