Save/Email/Recall (Setups, Screens, Data) 20
Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide 323
• Mask (*.msk) — This creates a mask file in a Keysight proprietary format that
can be read by Keysight InfiniiVision oscilloscopes. A mask data file includes
some oscilloscope setup information, but not all setup information. To save
all setup information including the mask data file, choose "Setup (*.scp)"
format instead. See “To save masks" on page 328.
• Arbitrary Waveform data (*.csv) — This creates a file of comma-separated
values for the arbitrary waveform points' time and voltage values. See “To
save arbitrary waveforms" on page 328.
• Analysis Results (*.csv) — A file of comma-separated values is saved for the
analysis types selected using the Analysis Select softkey.
• Current Harmonics data (*.csv), Power Supply Rejection Ration (PSRR) data (*.csv) ,
Control Loop Response (Bode) data (*.csv) — When the DSOX3PWR power
analysis application is licensed, these options create a file of
comma-separated values for the different types of analysis results. See the
PWR Power Measurement Application User's Guide for more information.
• Frequency Response Analysis data (*.csv) — This creates a file of
comma-separated values for the Frequency Response Analysis results table
values. In the saved file, there are three data columns: frequency (Hz), gain
(dB), and phase (degrees). See “To view and save the analysis results" on
page 298.
You can also configure the [Quick Action] key to save setups, screen images, or
data. See “Configuring the [Quick Action] Key" on page 357.
To save setup files
Setup files can be saved to one of 10 internal (\User Files) locations or to an
external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select Setup
(*.scp).
2 Press the softkey in the second position and use the Entry knob to navigate to
the save location. See “To navigate storage locations" on page 329.
3 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
Setup files have the extension SCP. These extensions appear when using the File
Explorer (see “File Explorer" on page 344), but they do not appear when using the
Recall Menu.
To Next Page
Loading...
