356 Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide
22 Utility Settings
To perform front panel self test
Pressing [Utility] > Service > Front Panel Self Test lets you test the front panel keys
and knobs as well as the oscilloscope display.
Follow the on-screen instructions.
To display oscilloscope information
Press [Help] > About Oscilloscope to display information about your oscilloscope:
• Model number.
• Serial number.
•Bandwidth.
•Module installed.
•Software version.
• Installed licenses. See also “Loading Licenses and Displaying License
Information" on page 378.
To display the user calibration status
Pressing [Utility] > Service > User Calibration Status displays the summary results of
the previous User Calibration, and the status of probe calibrations for probes that
can be calibrated. Note that passive probes do not need to be calibrated, but
InfiniiMax probes can be calibrated. For more information about calibrating probes
see “To calibrate a probe" on page 86.
To clean the oscilloscope
1 Remove power from the instrument.
2 Clean the external surfaces of the oscilloscope with a soft cloth dampened with
a mixture of mild detergent and water.
3 Make sure that the instrument is completely dry before reconnecting it to a
power source.
To check warranty and extended services status
To learn the warranty status of your oscilloscope:
1 Point your web browser to: www.keysight.com/find/warrantystatus
To Next Page
Loading...
Need help?
General
