Save/Email/Recall (Setups, Screens, Data) 20
Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide 329
3 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
See Also • “To edit arbitrary waveforms" on page 305
To navigate storage locations
When saving or recalling files, the softkey in the second position of the Save Menu
or Recall Menu, along with the Entry knob, are used to navigate to storage
locations. The storage locations can be internal oscilloscope storage locations (for
setup files or mask files) or they can be external storage locations on a connected
USB storage device.
The softkey in the second position can have these labels:
• Press to go — when you can push the Entry knob to navigate to a new folder or
storage location.
• Location — when you have navigated to the current folder location (and are not
saving files).
• Save to — when you can save to the selected location.
• Load from — when you can recall from the selected file.
When saving files:
• The proposed file name is shown in the Save to file = line above the softkeys.
• To overwrite an existing file, browse to that file and select it. To create a new file
name, see “To enter file names" on page 329.
To enter file names
To create new file names when saving files to a USB storage device:
1 In the Save Menu, press the File Name softkey.
You must have a USB storage device connected to the oscilloscope for this
softkey to be active.
2 In the File Name Menu, press the File Name softkey.
3 In the File Name keypad dialog, you can enter file names using:
• The touch screen (when the front panel [Touch] key is lit).
To Next Page
Loading...
Need help?
General
