Keysight MSOX3054T - 27 FlexRay Triggering and Serial Decode; Setup for FlexRay Signals

427
Keysight InfiniiVision 3000T X-Series Oscilloscopes
User's Guide
27 FlexRay Triggering and
Serial Decode
Setup for FlexRay Signals / 427
FlexRay Triggering / 428
FlexRay Serial Decode / 431
FlexRay triggering and serial decode requires the FLEX license that you can get by
purchasing the DSOX3FLEX upgrade.
Setup for FlexRay Signals
FlexRay signal setup consists of first connecting the oscilloscope to a differential
FlexRay signal using a differential active probe (the Keysight N2792A is
recommended), specifying the signal source, threshold voltage trigger level, baud
rate, and bus type.
To set up the oscilloscope to capture FlexRay signals:
1 Press [Serial].
2 Press the Serial softkey, turn the Entry knob to select the desired serial bus
(Serial 1 or Serial 2), and press the softkey again to enable decode.
3 Press the Mode softkey; then, select FlexRay mode.
4 Press the Signals softkey to open the FlexRay Signals Menu.