Keysight MSOX3054T User Manual

248 Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide
15 Measurements
Power App
Measurements
Note that additional Power App measurements are available when the
DSOX3PWR power measurement and analysis license is installed and the Power
Application is enabled. For more information, see the PWR Power Measurement
Application User's Guide at www.keysight.com/find/3000TX-Series-manual or on
the Documentation CD.
Dual-Channel
(N2820A Probe)
Measurements
Note that additional measurements are available with the N2820A high-sensitivity
current probe when both the Primary and Secondary probe cables are used.
Zoom In waveform data below the probe's clamp level is joined with Zoom Out
waveform data above the probe's clamp level to create the waveform on which the
measurement is made. These measurements are only valid for analog input
channels.
“Preshoot" on page 254
“Ratio" on page 257 Measures between two sources.
Press Settings to specify the second
source.
“Rise Time" on page 261
“DC RMS" on page 255
“AC RMS" on page 255
“Top" on page 251
“+ Width" on page 260 Yes
“– Width" on page 260 Yes
“X at Max Y" on page 264 Yes The resultant units are in Hertz.
“X at Min Y" on page 264 Yes The resultant units are in Hertz.
*
Use the cursors to make other measurements on FFT.
Measurement Valid
for
Math
FFT
*
Valid for
Digital
Channels
Notes
Dual-Channel (N2820A Probe)
Measurement
Notes
Amplitude See “Amplitude" on page 251.

Keysight MSOX3054T Specifications

General

Brand	Keysight
Model	MSOX3054T
Category	Test Equipment
Language	English