Utility Settings 22
Keysight InfiniiVision 3000T X-Series Oscilloscopes User's Guide 345
From a connected USB storage device, you can load setup files, mask files, license
files, firmware update (*.ksx) files, label files, etc. Also, you can delete files on a
connected USB storage device.
The oscilloscope's internal file system, under "\User Files", consists of 10 locations
for oscilloscope setup files, four locations for mask files, and four locations for
waveform generator arbitrary waveform files.
To use the File Explorer:
1 Press [Utility] > File Explorer.
2 In the File Explorer Menu, press the softkey in the first position and use the
Entry knob to navigate.
The softkey in the first position can have these labels:
The USB port on the front panel, and the USB port on the rear panel labeled "HOST" are USB
Series A receptacles. These are the receptacles to which you can connect USB mass storage
devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for controlling the
oscilloscope over USB. See the Programmer's Guide for more information.
To Next Page
Loading...
Need help?
General
