Crossover Assemblies
Adjustment for Squareness
NOTE
Use this procedure to check the
squareness of any of the
CROSSOVER ASSEMBLIES.
[1] Remove the CROSSOVER ASSEMBLY from
the processor.
[2] Place the CROSSOVER ASSEMBLY on a
smooth, flat surface.
[3] Loosen the 2 NUTS on the 2 TIE RODS.
[4] Check that the 2 SIDE PLATES touch the flat
surface evenly.
[5] Tighten the 2 NUTS.
Installation of a New Guide Shoe
[1] Remove the existing GUIDE SHOE SCREWS
and GUIDE SHOE.
[2] Install the GUIDE SHOE with the LONG TIPS
in the direction of film travel.
[3] Install the 2 GUIDE SHOE SCREWS.
H048_0155CA
H048_0155CCB
GUIDE
SHOE
LONG
TIP
SHORT
TIP
NOTE
Installing a Guide Shoe
The GUIDE SHOES have no adjustment procedures.
H112_0056BA
H112_0056BCA
TIE ROD
NUT
SIDE PLATE
NUT
LONG TIP
TIE ROD
SCREW (2)
GUIDE SHOE
PLATE
SIDE
2-6 981777
To Next Page
Loading...
