Replacement of the Resilient Rollers in the Wash Rack
[1] Remove the: [4] Remove the 2 SPRINGS.
• 2 SCREWS and the ID WASHER from the [5] Pull the 2 SHAFTS of the DRIVE ROLLER
TIE ROD and the DRIVEN ROLLER to the drive side to
remove them from the non-drive SIDE PLATE.
• SCREWS, WASHERS, DRIVE GEAR,
SPACERS, and BEARINGS from the DRIVE
[6] Bend the SIDE PLATE slightly to allow
and DRIVEN ROLLERS on the outside of
removal of the DRIVE ROLLER.
both SIDE PLATES
[7] Remove the THRUST WASHER, SPROCKET,
[2] Rotate the flat part of the SHAFT of the
and SPACERS.
DRIVE ROLLER to the up position.
[8] Reverse the procedure to install new resilient
[3] Move the DRIVE ROLLER to the non-drive
ROLLERS.
side and remove the KEY from the
SPROCKET.
H112_0105DA
H112_0105DCA
GEAR
DRIVE
ROLLER
DRIVEN
SHAFT
SPACER
SIDE PLATE
BEARING
WASHER
SCREW
SCREW
KEY
SPACER
SCREW (2)
ID WASHER
PIN
SPROCKET
(2)
SPRING
SHAFT
WASHER
THRUST
KEY
SPACER
PIN
ROD
TIE
ROLLER
DRIVE
Replacement of the Resilient Rollers of the Wash Rack
2-14 981777
To Next Page
Loading...
