Replacement of the Blower Assembly
[7] Install the BRACKET on the DRYER
HEATER.
Dangerous voltage.
[8] Install the 6 MOUNTING SCREWS.
[9] Tighten the MOUNTING SCREWS.
[1] Disconnect the main power.
[10] Connect the CABLE ASSEMBLY to the
[2] Remove the:
ELECTRICAL BOX.
• TOP COVER
[11] Install the:
• DRYER RACK
• SIDE PANELS
• RECEIVING END COVER
• RECEIVING END COVER
• SIDE PANELS
• DRYER RACK
• TOP COVER
Possible damage from electrostatic discharge.
[3] Disconnect CONNECTORS 801 and 802, not
shown, from the 800 CIRCUIT BOARD. See
the illustration on the next page for the
position of the 800 CIRCUIT BOARD.
[4] Disconnect the CABLE ASSEMBLY from the
ELECTRICAL BOX.
[5] See the illustration on page 2-24. Remove
the:
• 2 MOUNTING SCREWS from the
BRACKET
• 4 MOUNTING SCREWS from the DRYER
HEATER
• BLOWER MOTOR and BRACKET
• BLOWER MOTOR from the BRACKET
H112_0028AC
H112_0028ACB
TOP COVER
[6] Install the new BLOWER MOTOR and the
4 MOUNTING SCREWS on the BRACKET.
NOTE
Do not tighten the 4 MOUNTING
SCREWS on the BLOWER MOTOR
until step 9.
2-22 981777
To Next Page
Loading...
