Kodak M35 - Turnaround Assemblies

Drive Chain
[1] Manually rotate the DRIVE GEAR to check
the LINKS of the DRIVE CHAIN.
[2] Check the tension of the DRIVE CHAIN.
NOTE
If the DRIVE CHAIN is too tight, the
ROLLERS will bind and wear the
BEARINGS. If the DRIVE CHAIN is
too loose, the ROLLERS will not move
smoothly.
[3] If necessary, adjust the DRIVE CHAIN by
moving the TURNAROUND ASSEMBLY up or
down. Adjust both sides of the
TURNAROUND ASSEMBLY by the same
distance.
Springs
[1] Check the SPRINGS for wear. Install new
SPRINGS if necessary.
H112_0109CA
SPRING
SPROCKET
H112_0109CCB
DRIVE CHAIN
LINK
ASSEMBLY
TURNAROUND
GEAR
DRIVE
GEAR
SHAFT
BEARING
LOCKING
PLATE
Checking the Rack Assemblies
Turnaround Assemblies
[1] Remove the TURNAROUND ASSEMBLIES from the RACK ASSEMBLIES.
[2] Clean the DEVELOPER TURNAROUND ASSEMBLY with KODAK Liquid Developer System Cleaner.
[3] Clean the FIXER TURNAROUND ASSEMBLY with KODAK Liquid Fixer/Wash System Cleaner.
3-6 981777