Interlock Switch
[1] Check the operation of the INTERLOCK SWITCH:
(a) Press one of the RUN/STANDBY SWITCHES.
(b) Remove the TOP COVER. The MAIN DRIVE MOTOR, the BLOWER MOTOR, and the DRYER
HEATER will stop.
(c) If not, adjust the position of the MAGNETS on the TOP COVER.
(d) Install the TOP COVER and do steps (a) - (c) again.
[2] If the MAIN DRIVE MOTOR, the BLOWER MOTOR, and the DRYER HEATER do not stop, install a new
INTERLOCK SWITCH.
H112_0091BA
H112_0091BCA
TOP COVER
SWITCH
INTERLOCK
MAGNET
MAGNET
Replacement of the Interlock Switch
3-16 981777
To Next Page
Loading...
