Alignment of the Main Drive Motor
[1] Remove the drive SIDE PANEL, the
2 GUARD SCREWS, and the CHAIN GUARD.
[2] Loosen the 3 SETSCREWS.
[3] Align the SPROCKETS with the ends of the
DRIVE SHAFT and the MOTOR SHAFT.
[4] Tighten the 3 SETSCREWS.
[5] Check that the DRIVE CHAIN does not touch
the MOUNTING PLATE.
[6] Check that the SPROCKET on the DRIVE
SHAFT does not touch the DRIVE GEAR on
the DRYER RACK. See the illustration on
page 2-16.
[7] Install the CHAIN GUARD, the 2 GUARD
SCREWS, and the SIDE PANEL.
H112_0088CC
H112_0088CCA
SHAFT
MOTOR
CHAIN
DRIVE
PLATE
MOUNTING
SHAFT
DRIVE
SPROCKET (2)
SETSCREW (3)
Alignment of the Main Drive Motor
2-18 981777
To Next Page
Loading...
