Crossover Assemblies
[1] Remove the CROSSOVER ASSEMBLIES from the processor.
[2] Rinse the CROSSOVER ASSEMBLIES with running water.
[3] If necessary, use a soft brush and warm water or:
Developer/Fixer Crossover Assembly
Kodak
Liquid Developer System
Cleaner
Fixer/Wash Crossover Assembly
Kodak
Fixer/Wash System Cleaner
[4] Check the ROLLER GEARS for broken or worn teeth. Install new ROLLERS if necessary.
[5] Check that the RESILIENT ROLLER is smooth. Install a new RESILIENT ROLLER if necessary.
[6] Check the BEARING, BRACKETS, and NUTS for wear or broken parts. Install new parts if necessary.
[7] Check the DRIVE GEAR for wear or burrs. Install a new DRIVE GEAR if necessary.
[8] Place the CROSSOVER ASSEMBLIES on a flat surface with the GUIDE SHOES up.
[9] Check for squareness. See page 2-6 of this manual.
H112_0056BA
H112_0056BCB
BRACKET
SHOE
GUIDE
BEARING
GEAR
DRIVE
NUT
GEAR
ROLLER
ROLLER
Crossover Assembly
3-4 981777
To Next Page
Loading...
