Replenishment Pump
Replacement of the Replenishment Pump
Dangerous voltage.
[1] Disconnect the main power.
[2] Disconnect the water supply.
[3] Remove the:
• TOP COVER
• 2 SIDE PANELS
• RECEIVING BIN
• DRYER TEMPERATURE CONTROL KNOB
• PUMP COVER
• EXIT PANEL
H112_0115AC
DRYER
EXIT PANEL
TOP COVER
PUMP
COVER
SIDE PANEL (2)
TEMPERATURE
CONTROL KNOB
H112_0115ACB
[4] Disconnect the 2 MOTOR LEADS TB3-6 and
TB3-2 and the ground wire.
[5] Clamp the REPLENISHER TUBE.
[6] Remove the REPLENISHER TUBE LINES from the REPLENISHMENT PUMP.
[7] Remove and keep the 2 SCREWS, the 2 WASHERS, and the 2 LOCK WASHERS.
[8] Remove the REPLENISHMENT PUMP.
[9] Reverse the above procedure to install a new REPLENISHMENT PUMP.
H112_0097BA
H112_0097BCA
PUMP (2)
REPLENISHMENT
WASHER (2)
WASHER (2)
LOCK
SCREW (2)
TUBE LINES
REPLENISHER
Replacement of a Replenishment Pump
2-36 981777
To Next Page
Loading...
