Kodak M35 - Rack Assemblies

Rack Assemblies
Adjustment for Squareness
NOTE
Use this procedure to check the
squareness of any of the RACK
ASSEMBLIES.
[1] Remove the RACK ASSEMBLY from the
processor.
[2] Place the RACK ASSEMBLY on a smooth,
flat surface.
[3] Loosen the SCREWS on the ends of the
3 TIE RODS.
[4] Check that the 2 SIDE PLATES touch the flat
surface evenly.
[5] Tighten the SCREWS.
smooth, flat surface
H112_0110AA
H112_0017AC
H112_0017ACA
SIDE PLATE
SCREW (2)
TIE ROD
SIDE PLATE
Adjusting a Rack Assembly for Squareness
981777 2-7