Rack Assemblies
When you remove the FIXER RACK
ASSEMBLY, install a SPLASH GUARD
between the DEVELOPER TANK and
the FIXER TANK to prevent
contamination of the developer. Use a
DRIP TRAY when you remove the
RACK ASSEMBLIES. Install the
RACK ASSEMBLIES slowly into the
TANKS.
Rollers
[1] Remove the RACK ASSEMBLIES from the
H112_0015AC
DRIP TRAY
SPLASH GUARD
H112_0015ACA
processor.
[2] Rinse the RACK ASSEMBLIES with warm
water, approximately 44°C (110°F).
NOTE
Discoloration of the ROLLERS is normal.
[3] If necessary, use a soft brush or:
Developer Rack
Kodak
Liquid Developer
Assembly System Cleaner
.
Fixer Rack Assembly
Kodak
Fixer/Wash
System Cleaner
Wash Rack Assembly
smooth, flat surface
H112_0110AA
[4] Remove the STUDS from the drive side.
[5] Remove all the OUTER ROLLERS on the entrance side except the bottom OUTER ROLLER.
[6] Clean the INNER and OUTER ROLLERS.
[7] Check all SPROCKETS and GEARS for wear.
[8] Check that all ROLLERS are straight.
[9] Install the ROLLERS in the RACK ASSEMBLY.
[10] Check:
• That the ROLLERS are installed correctly.
• The REWET ROLLER for wear.
• That the REWET ROLLER is smooth.
• That the REWET ROLLER touches the ROLLERS above and below it.
• The RACK ASSEMBLY for squareness. See page 2-7.
981777 3-5
To Next Page
Loading...
