[6] Install new WORM GEARS or BEARING BLOCKS if necessary.
[7] Install the DRIVE SHAFT ASSEMBLY
[8] Place the SHIMS under the BEARING BLOCKS.
Do not overtighten the 4 SCREWS.
[9] Install the 4 SCREWS in the BEARING BLOCKS.
[10] Adjust the position of the BEARING BLOCKS until the DRIVE SHAFT moves freely.
[11] Install the DRIVE CHAIN.
[12] Adjust the DRIVE CHAIN. See page 2-8.
[13] Tighten the 4 MOUNTING SCREWS.
[14] Install the CHAIN GUARD.
2-20 981777
To Next Page
Loading...
