[5] Apply SEALANT TL-3230 to the threads of the
new DEVELOPER HEATER.
[6] Insert the new DEVELOPER HEATER into the
Overtightening the DEVELOPER
THERMOWELL.
HEATER may cause damage to the
[7] Check that the DEVELOPER HEATER is in
THERMOWELL.
the correct position through the HEATER
LOCATOR. See the illustration.
[8] Hand tighten the DEVELOPER HEATER plus
⁄
1
2
turn.
[9] Install the THERMOWELL and 2 SCREWS.
[10] Connect the wires to TB2-9 and TB2-10.
[11] Unclamp the 2 TUBES or fill the DEVELOPER
TANK.
60
5 mm
(13/64 in.)
13.9 cm
(5.500 .060 in.)
H048_0153BA
H048_0153BCA
HEATER LOCATOR
THERMOWELL
LOCATOR
HEATER
HEATER
DEVELOPER
Replacement of the Developer Heater
981777 2-29
To Next Page
Loading...
