bizhub C754/C654 14-9
14.1 Optional settings before file storage
14
Scan a number of originals in several batches ([Separate Scan])
If the number of original sheets is so large that they cannot be loaded into the ADF at the same time, you can
load them in several batches and handle them as one job.
In [Separate Scan], you can switch between the ADF and the Original Glass to scan the originals.
1 Load the original.
NOTICE
Do not load more than 150 sheets at a time into the original tray, and do not load the sheets up to the
point where the top of the stack is higher than the , mark. Doing so may cause an original paper jam,
damage the originals, and/or cause an ADF failure.
2 Tap [Application] - [No. of Originals] - [Separate Scan], and set to [ON].
% Set options if necessary.
3 Press the Start key.
The original is scanned.
4 Load the next original, then press Start key.
% If desired, tap [Change Setting] to change the option settings according to the new original.
5 Repeat Step 4 until all pages of the original are scanned.
6 After all originals are scanned, tap [Finish] and press the Start key.
To Next Page
Loading...
Need help?
General
