LUBRICANTS, FUEL, AND COOLANT
Lubricants, fuel, and coolant table
Locations
Capacities
Lubricants
MX5400 MX6000
Fuel
ROPS
51.0 L
(13.5 U.S.gals.)
No. 2-D S15 diesel fuel
No. 1-D S15 diesel fuel (If temperature is below -10 ℃ (14 ℉))
CAB
45.0 L
(11.9 U.S.gals.)
Coolant
6.5 L
(6.9 U.S.qts.)
Fresh clean soft water with antifreeze
Engine crankcase
with filter
7.0 L
(7.4 U.S.qts.)
For the engine oil, see the following Engine oil. CJ-4 (DPF type engine)
Above 25 ℃ (77 ℉)
SAE30, SAE10W-30, or
15W-40
-10 ℃ to +25 ℃
(14 ℉ to 77 ℉)
SAE20, SAE10W-30, or
15W-40
Below -10 ℃ (14 ℉) SAE10W-30
Transmission case
44.0 L
(11.6 U.S. gals.)
KUBOTA SUPER UDT-2 fluid
Front axle case [4WD]
8.5 L
(8.9 U.S.qts.)
KUBOTA SUPER UDT-2 fluid or SAE 80-SAE 90 gear oil
Greasing table
Greasing
No. of greasing points
Capacity Type of grease
MX5400 / MX6000
Front wheel hub [2WD only] 2 Moderate amount
Multipurpose Grease NLGI-2
or NLGI-1(GC-LB)
Knuckle shaft [2WD only] 2
Until grease overflows.
Front wheel case support [4WD only] 2
Front axle support [4WD only] 2
Top link 2
Top link bracket (with draft control (if equipped)) 2
Lift rod 1
Battery terminals 2 Moderate amount
NOTE :
• The product name of KUBOTA genuine UDT fluid may be different from that in the Operator’s Manual
depending on countries or territories. Consult your local KUBOTA Dealer for further details.
Engine oil
• Use the oil in the engine with an American-petroleum-institute (API) service classification and proper SAE engine
oil according to the ambient temperatures as shown in the preceding lubricants, fuel, and coolant table.
• See the following table for the suitable API classification engine oil according to the engine type with DPF (diesel-
particulate-filter) type engines and the fuel.
Fuel used
Engine oil classification (API classification)
Oil class of engines with EGR
Ultra low sulfur fuel (<0.0015% (15 ppm)) CJ-4
Fuel
• Use the preceding ultra low sulfur diesel fuel only for the engines.
MAINTENANCE LUBRICANTS, FUEL, AND COOLANT
To Next Page
Loading...
