9. Check the Easy Checker
™
lamps.
(See Easy Checker
™
lamps on page 36)
(1) Electrical charge indicator
(2) Parking brake indicator
(3) Engine oil pressure warning
indicator
(4) Glow plug indicator
(5) Water separator filter indica-
tor
NOTE :
• Some of the Easy Checker
™
lamps may light
up depending on the positions of the levers
and switches.
• Turn on the key switch, and some of the
indicators on the instrument panel stay on
about 1 second.
10. Turn the starter key to the “START” position and
release it when the engine starts.
IMPORTANT :
• Because of safety devices, the engine will
not start except the following conditions:
– PTO-clutch-control-switch is placed in
the “OFF” position.
– Speed-control-pedal is placed in the
“NEUTRAL” position.
11. Check to see that all the lamps on the Easy
Checker
™
are “OFF”.
If the lamps on the Easy Checker
™
is still on,
immediately stop the engine and determine the
cause.
STARTING THE ENGINE IN
COLD WEATHER
If the ambient temperature is as follows and the engine
is very cold, follow the procedure in this section to start
the engine.
Ambient temperature Below -5 ℃ (23 ℉)
1. Take the following steps of the procedure in the
Starting the engine section.
• [Manual transmission type]
Take the step 1. through step 9. of the
procedure in STARTING THE ENGINE
[MANUAL TRANSMISSION TYPE] on page 57.
• [HST type]
Take the step 1. through step 9. of the
procedure in STARTING THE ENGINE [HST
TYPE] on page 60.
OPERATING THE ENGINE STARTING THE ENGINE IN COLD WEATHER
To Next Page
Loading...
