5. Place the PTO-clutch-control-switch in the “OFF”
position.
(1) PTO clutch control switch (A) Push
(B) On (Engaged)
(C) Off (Disengaged)
6. Place the position-control-lever and the draft-
control-lever if equipped in the “FLOAT” position.
The “FLOAT” position is the lowest position of
position-control-lever and draft-control-lever.
(1) Position control lever
(2) Draft control lever (if equip-
ped)
(A) Down
7. Set the hand-throttle-lever to about 1/2 way.
(1) Hand throttle lever
(A) Increase
(B) Decrease
8. Insert the starter key into the key switch and turn it
“ON”.
[ROPS type]
[CAB type]
(1) Off
(2) On
(3) Start
(4) ACC
OPERATING THE ENGINE
To Next Page
Loading...
