EasyManua.ls Logo

Kubota MX6000 - Draining Water from the Water Separator

Kubota MX6000
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Loosen the air-purging-plug of the separator 2 turns
or so.
When the fuel coming out of the air-purging-plug-
hole contains no air bubbles, tighten the plug.
(1) Separator
(2) Fuel shutoff-valve
(3) Air purging plug
(A) Open
(B) Close
3. Loosen the air-purging-plug of the fuel filter 2 turns
or so.
4. Slowly move the feed-pump-knob up and down to
pump fuel.
The operating load on the feed-pump-knob is light
when air is pumped inside the fuel pipe, and so on,
but it becomes heavy when fuel is pumped.
Refer to the number of operations in the following
table to operate the feed-pump-knob.
Work description
Number of operations
When water is drained from the
separator and when disassembly
cleaning is performed
Approx. 10 times
When the tractor is not used for
many hours
When an engine stall occurs due to
running out of fuel or when fuel
pipes are removed
Approx. 60 times
When the fuel filter is replaced
5. Immediately after pumping fuel, tighten the air-
purging-plug of the fuel filter.
6. Operate the feed-pump-knob 4 or 5 times to
pressurize the circuit.
(1) Fuel filter
(2) Air purging plug
(3) Feed pump knob
(A) Press
7. Set the accelerator lever to the low speed position
and start the engine.
If the engine fails to start even after turning the
starter continuously for 10 seconds, turn if off for 30
seconds. And then repeat this a couple of times.
8. When the engine is started, wait for approx. 1
minute without performing any operation.
Afterwards, race the engine to purge a small
amount of air remaining in the fuel system.
9. In spite of the preceding step, if the engine stall
occurs due to air remaining in the system, perform
air purging again.
IMPORTANT :
Do not operate the feed pump unless the air-
purging-plug of the fuel filter is loosened.
2. Draining water from the water
separator
When separated water accumulates, the red float rises
up.
1. If water is accumulated, close the fuel shutoff-valve
and loosen the drain plug at the bottom to drain
water.
 PERIODIC SERVICE SERVICING AS REQUIRED
152
MX5400,MX6000

Table of Contents

Related product manuals