Kubota MX6000 - Engine Error Code; Power Train Troubleshooting

ENGINE ERROR CODE
If engine trouble should occur, the engine-warning-
indicator will appear and the error code that starts with
either [P] or [U] will appear on the liquid-crystal-display.
If the error code appears, please contact your local
KUBOTA Dealer for repairs immediately.
(1) Engine warning indicator (2) Error code
NOTE :
• Error code will not disappear even if the engine-
warning-indicator is reset.
POWER TRAIN
TROUBLESHOOTING
If something is wrong with the power train, the master-
system-warning-indicator starts blinking and the error
code shown in the following table is displayed on the
liquid-crystal-display, indicating the location of the
trouble. If an error code appears, immediately contact
your local KUBOTA Dealer for repairs.
(1) Master system warning indi-
cator
(2) Error code
Displayed
error code
Trouble Operator’s action
E-20
Communication trou-
ble
Contact your local KUBO-
TA Dealer.
E-21
CAN communication
trouble
E-30
Accelerator adjust-
ment trouble
E-40
Input voltage of lever
sensor from ECU is
in trouble.
E-84
Acceleration sensor
maladjusted
E-93
Relay for engine-
starter-motor is in
trouble.
Contact your local KUBO-
TA Dealer. The engine
cannot start.
E-94
Relay for engine-
shut-off is in trouble.
Contact your local KUBO-
TA Dealer. The operator-
presence-control (OPC)
system gets activated, and
the engine stops itself.
E-95
Solenoid (PTO) is in
trouble.
Contact your local KUBO-
TA Dealer. The PTO shaft
cannot rotate.
TROUBLESHOOTING ENGINE ERROR CODE
162
MX5400,MX6000