STARTING THE ENGINE [HST
TYPE]
1. Make sure that the parking brake is set.
(See To set the parking brake on page 44 if the
parking brake is not set)
(1) Brake pedal
(2) Parking brake lever
(A) Interlock the brake pedals
(B) Depress
(C) Pull
NOTE :
• The parking-brake-indicator in the Easy
Checker
™
comes on while the parking brake
is applied.
(1) Parking brake indicator
2. Make sure that the fuel shutoff-valve is in the
“OPEN” position.
(1) Fuel shutoff-valve
(A) Close
(B) Open
3. Make sure that the cruise-control-lever is in the
“OFF” position.
NOTE :
• Depress the both brake pedals together, and
the cruise-control-lever automatically
returns to the “OFF” position.
4. Place the speed-control-pedal and the range-gear-
shift-lever in the “NEUTRAL” position.
(1) Cruise control lever
(2) Speed control pedal
(3) Range gear shift lever
(A) Neutral position
(B) Off position
NOTE :
• When removing the foot from the speed-
control-pedal, the speed-control-pedal
automatically returns to the “NEUTRAL”
position.
OPERATING THE ENGINE STARTING THE ENGINE [HST TYPE]
To Next Page
Loading...
