EasyManua.ls Logo

Kubota MX6000 - Checking the Water Separator; Checking the Engine Oil Level

Kubota MX6000
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Checking the water separator
1. When the water has collected upper limit in the
water separator, the water separator indicator on
the instrument panel lights up and warning buzzer
sounding. In such case, loosen the drain plug by
several turns.
(1) Water separator indicator
2. Allow water to drain.
3. When no more water comes out and fuel starts to
flow out, retighten the drain plug.
4. Bleed the fuel system.
(1) Red float
(2) Cup
(3) Drain plug
(A) Fuel
(B) Upper limit
(C) Water
NOTE :
When the red float reaches near the upper
limit level, start from step 1 in the preceding
procedure to drain water in the water
separator.
IMPORTANT :
If water is drawn through to the fuel pump,
extensive damage will occur.
5. Checking the engine oil level
WARNING
To avoid personal injury or death:
Be sure to stop the engine and remove the
starter key before checking the engine-oil-level.
Check the engine oil before starting the engine or 5
minutes or more after the engine has stopped.
1. Park the machine on a flat surface.
2. To check the engine-oil-level, draw out the dipstick.
3. Wipe the dipstick clean.
4. Replace the dipstick.
5. Draw the dipstick out again.
6. Check to see that the engine-oil-level lies between
the 2 notches.
DAILY CHECK  PERIODIC SERVICE
MX5400,MX6000
125

Table of Contents

Related product manuals