Kubota MX6000 - Antifrost Heater for Oil Separator (if Equipped); Block Heater (if Equipped)

2. Turn the starter key to the “ON” (glow plug) position
and keep it there for 10 seconds.
To protect the battery and the starter, make sure
that the starter is not continuously turned for more
than 10 seconds.
[ROPS type]
[CAB type]
(1) Off
(2) On
(3) Start
(4) ACC
NOTE :
• Glow-plug-indicator comes on while the
engine is being preheated.
(1) Glow plug indicator
3. Turn the starter key to the “START” position.
The engine should start.
If the engine fails to start after keeping the starter
key preheat position for 10 seconds, turn off the
starter key for 30 seconds. Then repeat step 2. and
step 3.
1. Antifrost heater for oil separator
(if equipped)
The heater element operates continuously when the
key switch is in the “ON” or “START” position.
Due to high electrical draw, extended idle time or
operations will drain the battery and stop the tractor.
[ROPS type]
(1) Heater (oil separator) (out1)
(2) Heater (oil separator) (out2)
(3) Heater (oil separator) (in1)
(4) Heater (oil separator) (in2)
[CAB type]
(5) Heater (oil separator) (in)
2. Block heater (if equipped)
A block heater is available as an option from your
dealer.
Block heater will assist you in starting your tractor when
the ambient temperature is as follows.
Ambient temperature
Below -20 ℃ (-4 ℉)
STARTING THE ENGINE IN COLD WEATHER OPERATING THE ENGINE
MX5400,MX6000
63