charger, and the negative terminal of battery to the
negative terminal of charger. Then recharge in the
standard fashion.
A boost charge is only for emergencies. Boost
charge will partially charge the battery at a high rate
and in a short time.
When using a boost-charged battery, it is necessary
to recharge the battery as early as possible.
Failure to recharge the battery may shorten the
service life of battery.
The battery is charged if the indicator display turns
green from black.
2. When exchanging an old battery for a new one, use
the battery of equal specification shown in the
following table.
Battery
type
Volts
(V)
Re-
serve
capaci-
ty (min)
CCA
(SAE)
(A)
Normal
charg-
ing rate
(A)
ROPS 80D26R 12 120 600 7.5
CABIN 85D26R 12 130 650 7.5
CCA
Cold cranking ampere
Direction for battery storage
1. When storing the tractor for long periods of time,
follow the following procedure.
a. Remove the battery from the tractor.
b. Adjust the electrolyte to the proper level.
c. Store the battery in a dry place out of direct
sunlight.
2. Recharge the battery once every three months in
hot seasons and once every six months in cold
seasons.
The battery self-discharges while it is stored.
SERVICE EVERY 200 HOURS
1. Replacing the transmission oil
filter [HST type only]
WARNING
To avoid personal injury or death:
• Be sure to stop the engine and remove the
starter key before changing the transmission-
oil-filter-cartridge.
• Allow the engine to cool down sufficiently
because the transmission oil can be hot and
can burn.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
• Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the transmission.
1. Remove the drain plugs at the bottom of the
transmission case and drain the transmission oil
completely into the oil pan.
2. After draining the transmission oil, reinstall the drain
plugs.
(1) Drain plugs
3. Remove the transmission-oil-filter.
(1) Transmission oil filter [HST
type]
4. Put a film of clean transmission oil on the rubber
seal of the new transmission-oil-filter.
5. Quickly tighten the transmission-oil-filter until it
contacts the mounting surface, then, with a filter
wrench, tighten the transmission-oil-filter an
additional one turn only.
SERVICE EVERY 200 HOURS PERIODIC SERVICE
To Next Page
Loading...
