2. Lubricating the grease fittings
[4WD]
1. Apply a small amount of multipurpose grease to the
following points every 50 hours.
If you have operated the machine in extremely wet
and muddy conditions, lubricate the grease fittings
more often.
(1) Grease fitting (front axle sup-
port)
(2) Grease fitting (front wheel
case support) [RH, LH]
(3) Grease fitting (top link)
(4) Grease fitting (lifting rod)
[RH]
(5) Grease fitting (top link brack-
et with draft control)(if equip-
ped)
(6) Battery terminals
2. When applying the grease to the forward front-axle-
support, follow the following the procedure.
a. Remove the breather plug.
b. Apply grease until the grease overflows from
the breather-plug-port.
c. After greasing, reinstall the breather plug.
(1) Grease fitting (forward front
axle support)
(2) Breather plug
3. Checking the engine start system
[Manual transmission type]
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparation before testing
1. Place all the control levers in the “NEUTRAL”
position.
2. Set the parking brake and stop the engine.
SERVICE EVERY 50 HOURS PERIODIC SERVICE
To Next Page
Loading...
