EasyManua.ls Logo

Kubota MX6000 - Checking Antifrost Heater for Oil Separator (if Equipped)

Kubota MX6000
172 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Fill the fuel tank when the fuel gauge shows 1/4 or
less fuel in tank.
(1) Fuel tank cap
Fuel tank capacity
[ROPS]
51 L
(13.5 U.S.gals.)
[CAB]
45 L
(11.9 U.S.gals.)
3. Checking antifrost heater for oil
separator (if equipped)
WARNING
To avoid personal injury or death:
Because there are rotating parts like the fan,
and so on, near the inspection position, keep
the engine off during inspection.
When operating tractors with antifrost heaters for oil
separator in cold regions (below the freezing point
(0 )), carry out inspection by using the procedure in
this section before starting work.
1. Turn the key switch to “ON”, and 1 minute later,
inspect by touch whether the heater is working.
If the heater is working, its temperature will rise to
roughly as follows, so you will be able to feel its
warmth.
Heater temperature
70
[ROPS type]
(1) Heater (oil separator) (out1)
(2) Heater (oil separator) (out2)
(3) Heater (oil separator) (in1)
(4) Heater (oil separator) (in2)
[CAB type]
(5) Heater (oil separator) (in)
IMPORTANT :
See the following figure for the heater
inspection position.
2. If the heater is not warm, it is not working. In this
case, contact your local KUBOTA Dealer without
starting the engine.
 PERIODIC SERVICE DAILY CHECK
124
MX5400,MX6000

Table of Contents

Related product manuals