(1) Synchro-shuttle shift lever
(2) Clutch pedal
(3) PTO clutch control switch
Test of switch for the synchro-shuttle shift lever
1. Sit on the operator's seat.
2. Shift the synchro-shuttle shift lever to the
“FORWARD” or “REVERSE” position.
3. Depress the clutch pedal fully.
4. Disengage the PTO-clutch-control-switch.
5. Turn the starter key to the “START” position.
6. Make sure that the engine does not crank.
7. If the engine cranks, consult your local KUBOTA
dealer for servicing the synchro-shuttle shift lever.
Test of switch for the PTO clutch control switch
1. Sit on the operator's seat.
2. Engage the PTO-clutch-control-switch.
3. Depress the clutch pedal fully.
4. Shift the shuttle-shift-lever to the “NEUTRAL”
position.
5. Turn the starter key to the “START” position.
6. Make sure that the engine does not crank.
7. If the engine cranks, consult your local KUBOTA
dealer for servicing the PTO-clutch-control-switch.
4. Checking the engine start system
[HST type]
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparation before testing
1. Place all the control levers in the “NEUTRAL”
position.
2. Set the parking brake and stop the engine.
(1) Speed control pedal (2) PTO clutch control switch
Test of switch for the speed control pedal
1. Sit on the operator's seat.
2. Depress the speed-control-pedal to the desired
direction.
3. Disengage the PTO-clutch-control-switch.
4. Turn the starter key to the “START” position.
5. Make sure that the engine does not crank.
6. If the engine cranks, consult your local KUBOTA
dealer for servicing the speed-control-pedal.
Test of switch for the PTO clutch control switch
1. Sit on the operator's seat.
2. Engage the PTO-clutch-control-switch.
3. Place the speed-control-pedal in the “NEUTRAL”
position.
4. Turn the starter key to the “START” position.
5. Make sure that the engine does not crank.
6. If the engine cranks, consult your local KUBOTA
dealer for servicing the PTO-clutch-control-switch.
5. Checking the operator presence
control
Check if the engine shuts off when you stand up from
the operators seat.
WARNING
To avoid personal injury or death:
• Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparing for the checking
1. Place all control levers in the “NEUTRAL” position.
2. Set the parking brake and stop the engine.
PERIODIC SERVICE SERVICE EVERY 50 HOURS
To Next Page
Loading...
